Frost Line Depth in Washington
- 27 verified values
- 48 places covered
- Checked Oct 2026
Verified range
12–24 in across Washington
Washington’s code leaves frost line depth to each city or county, which writes it into its own code.
State document: up.codes
How deep is the frost line in Washington?
Washington has no single statewide frost line depth. Washington’s code leaves frost line depth to each city or county, which writes it into its own code. The 27 verified local values we have read range from 12 to 24 inches, so check your own city or county.
Who sets the frost line depth in Washington?
Under IRC Table R301.2, the jurisdiction fills in the frost line depth as the minimum depth of footing below finish grade. In Washington that job falls to each city or county, so the number lives in local codes rather than in one state table, and two neighbouring places can differ.
“The jurisdiction shall fill in the frost line depth column with the minimum depth of footing below finish grade.”
State document: up.codes, read October 2026.
What frost depths do Washington jurisdictions use?
The Washington State Residential Code leaves the frost depth to each jurisdiction. Seattle’s 2021 code lists 12 inches, with a 20 psf snow load and an air freezing index of 250. North of Seattle, Snohomish County and Marysville use 18 inches, and Whatcom County uses 18 inches west of longitude 122°54′30″.
Frost line depth in Washington cities and counties
Every Washington place we cover, largest first. Verified values come from the place’s own code or the state rule; the others show nearby official values and who to ask.
| Place | Frost line | Type |
|---|---|---|
| King County | 12 in Below 1,000 ft, Deeper Above | County |
| Pierce County | 18 in | County |
| Snohomish County | 18 in | County |
| Spokane County | 24 in | County |
| Clark County | 12 in | County |
| Thurston County | No official local value | County |
| Kitsap County | No official local value | County |
| Yakima County | 12 in | County |
| Whatcom County | 18 in | County |
| Spokane | No official local value | City |
| Tacoma | 12 in | City |
| Bellevue | No official local value | City |
| Skagit County | 12 in | County |
| Cowlitz County | 12 in | County |
| Everett | 18 in | City |
| Spokane Valley | 24 in | City |
| Renton | No official local value | City |
| Grant County | 18 in | County |
| Franklin County | 24 in | County |
| Federal Way | No official local value | City |
| Yakima | No official local value | City |
| Bellingham | No official local value | City |
| Kirkland | 18 in | City |
| Island County | No official local value | County |
| Lewis County | 12 in | County |
| Kennewick | No official local value | City |
| Auburn | No official local value | City |
| Redmond | 12 in | City |
| Pasco | 24 in | City |
| Chelan County | No official local value | County |
| Clallam County | 12 in | County |
| Grays Harbor County | No official local value | County |
| Marysville | 18 in | City |
| Mason County | 12 in | County |
| Sammamish | No official local value | City |
| Richland | No official local value | City |
| Lakewood | No official local value | City |
| Walla Walla County | No official local value | County |
| Lacey | No official local value | City |
| Burien | No official local value | City |
| Stevens County | No official local value | County |
| Kittitas County | 24 in | County |
| Bremerton | 12 in | City |
| Douglas County | 24 in | County |
| Lynnwood | 18 in | City |
| Okanogan County | 24 in | County |
| Edmonds | No official local value | City |
| Lake Stevens | 12 in | City |
How deep do footings need to be in Washington?
Exterior footings go at least 12 inches below undisturbed ground and below the depth your city or county sets, measured to the bottom of the footing. The residential code (IRC R403.1.4.1) also accepts a frost-protected shallow foundation, a design to ASCE 32 or solid rock in place of digging to the frost line, and it exempts small free-standing accessory buildings: light-frame ones up to 600 square feet with eaves 10 feet high or lower. Washington may amend these rules, so confirm them with your building department. More detail: footing depth.
How deep should deck footings and fence posts be in Washington?
A deck attached to the house needs footings below the depth your city or county sets. Under the 2021 and 2024 IRC a free-standing deck needs footings only 12 inches deep, and the 2018 edition exempts free-standing decks from the frost rule, so the answer depends on the edition Washington adopted. See deck footing depth.
The residential code sets no fence-post depth, and fences up to 7 feet tall are exempt from a building permit (IRC R105.2), though zoning still applies. A common practice is to bury about half the above-ground height, and to reach the frost line when posts are set in concrete. See fence post depth.
How deep are water lines buried in Washington?
Under the IRC plumbing rule (P2603.5), a water service line goes at least 12 inches deep and at least 6 inches below the frost line. States that use the Uniform Plumbing Code or their own plumbing rules word this differently, so ask your plumbing inspector which code applies in Washington. See water line depth.
How cold do Washington winters get?
Across the 48 Washington places we track, nights at or below 32 °F range from 21 a year in Lakewood to 177 in Chelan County. The average low in the coldest month runs from 20.3 °F in Stevens County to 37.1 °F in Burien (NOAA 1991–2020 normals, nearest station). Colder winters drive frost deeper in a hard year, but the code depth does not change with the weather. See frost penetration depth.
How do Washington soils affect frost heave?
The USDA soil survey rates how prone soil is to frost action. Around the 48 Washington places we sampled, the main rating is none at 25 places, moderate at 11 places, high at 7 places and low at 5 places. Fine, wet soils rated moderate or high heave the most, so drainage and clean gravel backfill matter more there. The rating does not change the code depth. See frost heave.
How do you confirm the frost line with your Washington building department?
- Find your city or county in the table above, or enter your ZIP code; a ZIP can cross into a second county.
- Ask the building department what frost line depth it uses for Table R301.2, measured to the bottom of the footing, and whether it has local rules for decks, sheds or fences.
- Ask the plumbing inspector how deep water and sewer lines must go.
- Call 811 a few days before you dig so buried utilities are marked.