Frost Line Depth in Utah

  • 14 verified values
  • 26 places covered
  • Checked Oct 2026

Verified range

30–36 in across Utah

Utah’s code leaves frost line depth to each city or county, which writes it into its own code.

State document: up.codes

How deep is the frost line in Utah?

Utah has no single statewide frost line depth. Utah’s code leaves frost line depth to each city or county, which writes it into its own code. The 14 verified local values we have read range from 30 to 36 inches, so check your own city or county.

Who sets the frost line depth in Utah?

Under IRC Table R301.2, the jurisdiction fills in the frost line depth as the minimum depth of footing below finish grade. In Utah that job falls to each city or county, so the number lives in local codes rather than in one state table, and two neighbouring places can differ.

“The jurisdiction shall fill in the frost line depth column with the minimum depth of footing below finish grade.”

State document: up.codes, read October 2026.

Why do most Utah cities use 30 inches?

Utah’s residential code leaves the frost depth to each jurisdiction, and the Wasatch Front has settled on 30 inches. Salt Lake City, Provo, Ogden, Kaysville, West Jordan, Millcreek, Eagle Mountain and Salt Lake County’s municipal services district all publish 30 inches in their design criteria.

Frost line depth in Utah cities and counties

Every Utah place we cover, largest first. Verified values come from the place’s own code or the state rule; the others show nearby official values and who to ask.

Utah frost line depths, checked Oct 2026
PlaceFrost lineType
Salt Lake County30 in (More at High Elevations)County
Davis CountyNo official local valueCounty
Weber CountyNo official local valueCounty
Washington CountyNo official local valueCounty
Cache CountyNo official local valueCounty
West Valley CityNo official local valueCity
West Jordan30 inCity
Provo30 inCity
St. GeorgeNo official local valueCity
Orem30 inCity
LehiNo official local valueCity
South Jordan30 inCity
LaytonNo official local valueCity
Tooele County30 in or More by LocationCounty
Iron CountyNo official local valueCounty
Box Elder County30 inCounty
Millcreek30 inCity
Herriman30 inCity
TaylorsvilleNo official local valueCity
Eagle Mountain30 inCity
Logan30 inCity
DraperNo official local valueCity
Murray30 inCity
Riverton30 inCity
BountifulNo official local valueCity
Summit County36 inCounty

How deep do footings need to be in Utah?

Exterior footings go at least 12 inches below undisturbed ground and below the depth your city or county sets, measured to the bottom of the footing. The residential code (IRC R403.1.4.1) also accepts a frost-protected shallow foundation, a design to ASCE 32 or solid rock in place of digging to the frost line, and it exempts small free-standing accessory buildings: light-frame ones up to 600 square feet with eaves 10 feet high or lower. Utah may amend these rules, so confirm them with your building department. More detail: footing depth.

How deep should deck footings and fence posts be in Utah?

A deck attached to the house needs footings below the depth your city or county sets. Under the 2021 and 2024 IRC a free-standing deck needs footings only 12 inches deep, and the 2018 edition exempts free-standing decks from the frost rule, so the answer depends on the edition Utah adopted. See deck footing depth.

The residential code sets no fence-post depth, and fences up to 7 feet tall are exempt from a building permit (IRC R105.2), though zoning still applies. A common practice is to bury about half the above-ground height, and to reach the frost line when posts are set in concrete. See fence post depth.

How deep are water lines buried in Utah?

Under the IRC plumbing rule (P2603.5), a water service line goes at least 12 inches deep and at least 6 inches below the frost line. States that use the Uniform Plumbing Code or their own plumbing rules word this differently, so ask your plumbing inspector which code applies in Utah. See water line depth.

How cold do Utah winters get?

Across the 26 Utah places we track, nights at or below 32 °F range from 62 a year in St. George to 234 in Summit County. The average low in the coldest month runs from 4.7 °F in Summit County to 27.9 °F in St. George (NOAA 1991–2020 normals, nearest station). Colder winters drive frost deeper in a hard year, but the code depth does not change with the weather. See frost penetration depth.

How do Utah soils affect frost heave?

The USDA soil survey rates how prone soil is to frost action. Around the 26 Utah places we sampled, the main rating is moderate at 18 places, high at 6 places, none at 1 place and low at 1 place. Fine, wet soils rated moderate or high heave the most, so drainage and clean gravel backfill matter more there. The rating does not change the code depth. See frost heave.

How do you confirm the frost line with your Utah building department?

  1. Find your city or county in the table above, or enter your ZIP code; a ZIP can cross into a second county.
  2. Ask the building department what frost line depth it uses for Table R301.2, measured to the bottom of the footing, and whether it has local rules for decks, sheds or fences.
  3. Ask the plumbing inspector how deep water and sewer lines must go.
  4. Call 811 a few days before you dig so buried utilities are marked.