Frost Line Depth in Maryland
- 5 verified values
- 7 places covered
- Checked Oct 2026
Verified range
18–36 in across Maryland
Maryland’s code leaves frost line depth to each city or county, which writes it into its own code.
State document: up.codes
How deep is the frost line in Maryland?
Maryland has no single statewide frost line depth. Maryland’s code leaves frost line depth to each city or county, which writes it into its own code. The 5 verified local values we have read range from 18 to 36 inches, so check your own city or county.
Who sets the frost line depth in Maryland?
Under IRC Table R301.2, the jurisdiction fills in the frost line depth as the minimum depth of footing below finish grade. In Maryland that job falls to each city or county, so the number lives in local codes rather than in one state table, and two neighbouring places can differ.
“The jurisdiction shall fill in the frost line depth column with the minimum depth of footing below finish grade.”
State document: up.codes, read October 2026.
Which Maryland counties use 18, 24 or 30 inches?
Maryland adopts the IRC statewide, and each county and Baltimore City fills in its own design table. The frost depth falls into four groups. Somerset, Wicomico and Worcester counties use 18 inches; St. Mary’s uses 20. Calvert, Caroline, Charles, Dorchester, Queen Anne’s and Talbot use 24 inches. Anne Arundel, Baltimore City, Baltimore County, Carroll, Frederick, Harford, Howard, Montgomery, Prince George’s and Washington counties use 30 inches.
Frost line depth in Maryland cities and counties
Every Maryland place we cover, largest first. Verified values come from the place’s own code or the state rule; the others show nearby official values and who to ask.
| Place | Frost line | Type |
|---|---|---|
| Prince George's County | 30 in | County |
| Calvert County | 24 in | County |
| Gaithersburg | No official local value | City |
| Allegany County | 36 in | County |
| Bowie | No official local value | City |
| Worcester County | 18 in | County |
| Queen Anne's County | 24 in | County |
How deep do footings need to be in Maryland?
Exterior footings go at least 12 inches below undisturbed ground and below the depth your city or county sets, measured to the bottom of the footing. The residential code (IRC R403.1.4.1) also accepts a frost-protected shallow foundation, a design to ASCE 32 or solid rock in place of digging to the frost line, and it exempts small free-standing accessory buildings: light-frame ones up to 600 square feet with eaves 10 feet high or lower. Maryland may amend these rules, so confirm them with your building department. More detail: footing depth.
How deep should deck footings and fence posts be in Maryland?
A deck attached to the house needs footings below the depth your city or county sets. Under the 2021 and 2024 IRC a free-standing deck needs footings only 12 inches deep, and the 2018 edition exempts free-standing decks from the frost rule, so the answer depends on the edition Maryland adopted. See deck footing depth.
The residential code sets no fence-post depth, and fences up to 7 feet tall are exempt from a building permit (IRC R105.2), though zoning still applies. A common practice is to bury about half the above-ground height, and to reach the frost line when posts are set in concrete. See fence post depth.
How deep are water lines buried in Maryland?
Under the IRC plumbing rule (P2603.5), a water service line goes at least 12 inches deep and at least 6 inches below the frost line. States that use the Uniform Plumbing Code or their own plumbing rules word this differently, so ask your plumbing inspector which code applies in Maryland. See water line depth.
How cold do Maryland winters get?
Across the 7 Maryland places we track, nights at or below 32 °F range from 86 a year in Gaithersburg to 112 in Bowie. The average low in the coldest month runs from 21.6 °F in Bowie to 30.2 °F in Worcester County (NOAA 1991–2020 normals, nearest station). Colder winters drive frost deeper in a hard year, but the code depth does not change with the weather. See frost penetration depth.
How do Maryland soils affect frost heave?
The USDA soil survey rates how prone soil is to frost action. Around the 7 Maryland places we sampled, the main rating is moderate at 5 places and high at 2 places. Fine, wet soils rated moderate or high heave the most, so drainage and clean gravel backfill matter more there. The rating does not change the code depth. See frost heave.
How do you confirm the frost line with your Maryland building department?
- Find your city or county in the table above, or enter your ZIP code; a ZIP can cross into a second county.
- Ask the building department what frost line depth it uses for Table R301.2, measured to the bottom of the footing, and whether it has local rules for decks, sheds or fences.
- Ask the plumbing inspector how deep water and sewer lines must go.
- Call 811 a few days before you dig so buried utilities are marked.